Here’s a closer look at all of this and how to use flux when soldering electronics. The key to getting a good solder joint is in using a chemical cleaning agent known as flux before and during the soldering process. And if paying a traffic ticket for not having current license plates on your car is expensive, just wait until you start getting the bills for the component failures on your circuit boards due to bad solder joints. If the metal surface of the board isn’t clean and prepared for the solder, you won’t get a good metallurgical bond between the surfaces. This same principle applies when electronic components are soldered to a circuit board. The key to preventing this from happening is to make sure that the surface of the license plate is clean and dry before applying the labels. This can lead to an impromptu road-side meeting with a police officer who will want you to pay some additional fees. You have to be careful though because if not applied correctly, these labels may detach while you are driving down the road. After getting the car tested and paying the fee, I was given the two small registration date labels for the license plates.
A couple of weeks ago I went through the biennial process of renewing the registration on my wife’s car.
0 kommentar(er)
